The the customer display will display its configuration when the system is powered on. The customer display is internaly connected to the serial COM 4, with the default settings of ESC/POS mode, 9600 baud, 8 data bits, 1 stop bit, no parity, no flow control. You can however use the default driver included with Windows 7, but it will not be possible to manage a dual display output. Windows 7 drivers are available for the Odysse system on the v1.4 drivers disk, but there is no driver for the VGA chip. Is the Odysse compatible with Windows 7 ? The Windows 7 drivers can be found on the current v2.01 drivers disk. Yes – The Odysse-II is fully compatible with Windows 7. Is the Odysse-II compatible with Windows 7 ? No – The customer display is exactly the same & is still connected to Com4 (default settings: 9600,n,8,1) The address is now HEX 48C (decimal 1164), with a fire code of HEX 04.Īre there any changes to the customer display ? No – The cash drawer port address for the Odysse-II system is not the same as all the other Aures systems. Is the cash drawer port address still the same for the Odysse-II ? No – You must create a new software image for the Odysse-II system, because the motherboard & chipset are different & the drivers are therefore not the same. Can I still use this image on the Odysse-II system ? I already have a software image prepared for the Odysse system. Aures ODYSSE II Epos Repairs refurbishment support rebuilds & refinishing
0 Comments
Leave a Reply. |